83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
| *a | Adhesive |
| *b | Oil Inlet Port |
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Do not start the engine for at least 1 hour after installation.
Connect the engine oil pressure switch assembly connector.
2.INSPECT FOR OIL LEAK
51443C
3.INSTALL REAR ENGINE UNDER COVER RH