Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › COOLING SYSTEM
RM32K0E _51 Engine / Hybrid System _060780 2ZR-FXE COOLING _0298023 COOLING SYSTEM G

2ZR-FXE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A389829

Do not remove the reserve tank cap and air release valve while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK (for Engine)

CAUTION:

Do not remove the reserve tank cap and air release valve while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.
A448592C06
1.042,1.406 1.26,1.406 1.26,1.406 1.563,1.073 false 1.021,1.677 1.208,1.677 1.208,1.677 1.615,1.24 false 2.198,1.188 2.625,1.188 false 0.875,1.302 1.188,1.458 0.313,0.156 10 false *a 0.854,1.583 1.167,1.74 0.313,0.156 10 false *b 2.688,1.104 3,1.26 0.313,0.156 10 false *c 2.979,0.365 3.292,0.521 0.313,0.156 10 false *d
*a FULL Line
*b LOW Line
*c Compartment 1
*d Engine Coolant Level


Confirm that the engine coolant level in compartment 1 of the radiator reserve tank assembly is full.

If the engine coolant in compartment 1 is not full, perform steps (*1) to (*3) of the "ADD ENGINE COOLANT (for Engine)" procedure.

Click hereGeneral>MAINTENANCE>2ZR-FXE COOLANT (for Engine Coolant)>REPLACEMENT


b.

Remove the reserve tank cap.


c.

Add engine coolant to the FULL line of the radiator reserve tank assembly.


d.
A391005C02
0.646,1.146 0.854,1.146 0.854,1.146 1.052,0.833 false 0.479,1.052 0.792,1.208 0.313,0.156 10 false *a
*a Radiator Cap Tester


Install a radiator cap tester.


e.

Put the engine in inspection mode (maintenance mode).

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON (IG).


iii.

Turn the GTS on.


iv.

Enter following menus: Powertrain / Hybrid Control / Utility / Inspection Mode.

Powertrain > Hybrid Control > Utility
Tester Display
Inspection Mode
50005 397 2103


f.

Warm up the engine.


g.

Pump the radiator cap tester to 122 kPa (1.2 kgf/cm2, 17 psi), and then check that the pressure does not drop.

·

If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



h.

Remove the radiator cap tester.


i.

Install the reserve tank cap.


Hide 2.INSPECT RADIATOR RESERVE TANK ENGINE COOLANT LEVEL (for Engine)

a.
A448592C07
1.042,1.406 1.26,1.406 1.26,1.406 1.563,1.073 false 1.021,1.677 1.208,1.677 1.208,1.677 1.615,1.24 false 2.198,1.188 2.625,1.188 false 0.875,1.302 1.188,1.458 0.313,0.156 10 false *a 0.854,1.583 1.167,1.74 0.313,0.156 10 false *b 2.688,1.104 3,1.26 0.313,0.156 10 false *c 2.979,0.365 3.292,0.521 0.313,0.156 10 false *d
*a FULL Line
*b LOW Line
*c Compartment 1
*d Engine Coolant Level


When the engine is cold, confirm that the engine coolant level of the radiator reserve tank assembly is between the FULL and LOW lines and that the engine coolant level of compartment 1 is full.

·

If the engine coolant level is below the LOW line, check for leaks and add engine coolant to the FULL line.

·

If the engine coolant in compartment 1 is not full, perform steps (*1) to (*3) of the "ADD ENGINE COOLANT (for Engine)" procedure.

Click hereGeneral>MAINTENANCE>2ZR-FXE COOLANT (for Engine Coolant)>REPLACEMENT


NOTICE:

Do not substitute plain water for engine coolant.



Hide 3.INSPECT ENGINE COOLANT QUALITY (for Engine)

CAUTION:

Do not remove the reserve tank cap and air release valve while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the reserve tank cap.


b.

Check if there are any excessive deposits of rust or scale around the reserve tank cap and radiator reserve tank filler hole. Also, the engine coolant should be free of oil.

If excessively dirty, clean the engine coolant passage and replace the engine coolant.


c.

Install the reserve tank cap.