Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › COOLING FAN MOTOR › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _060780 2ZR-FXE COOLING _0298029 COOLING FAN MOTOR A

2ZR-FXE COOLING  COOLING FAN MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the cooling fan motor LH or cooling fan motor RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link

*: w/ Grille Shutter System

Removal/installation of front bumper assembly Change grille shutter control modes and/or perform initialization* Grille shutter system (Click here)

PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

Hide 16361J 2.REMOVE FAN RH

a.
A394230

Remove the nut and fan RH.


Hide 16361K 3.REMOVE FAN LH

a.
A394231

Remove the nut and fan LH.


Hide 16363F 4.REMOVE COOLING FAN MOTOR RH

a.
A394668

Remove the 3 screws and cooling fan motor RH.


Hide 16363G 5.REMOVE COOLING FAN MOTOR LH

a.
A394669

Disengage the 3 clamps.


b.
A394670

Remove the 3 screws and cooling fan motor LH.