Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43040B
1.INSTALL FRONT DRIVE INBOARD JOINT HOLE SNAP RING
Install a new front drive inboard joint hole snap ring.
43420
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the splines of the front drive inboard joint assembly with ATF WS.
Coat the lip of the front drive shaft oil seal LH with MP grease.
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.
Face the end gap of the front drive shaft hole snap ring downward.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
|
Toyota Body Grease W |
Apply 0.1 to 0.3 g (0.00353 to 0.0105 oz) of Toyota Body Grease W to each of the 4 areas shown in the illustration.
| *a | Matchmark |
Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.
Do not push the front axle assembly towards the outside of the vehicle any further than necessary.
Check that there is no foreign matter on the deflector or contact surfaces.
Do not damage the front drive shaft outboard joint boot.
Do not damage the front disc brake dust cover.
Do not damage the deflector.
43410
3.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Perform the same procedure as for the LH side.
48069
4.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
48810
5.INSTALL FRONT STABILIZER LINK ASSEMBLY
45047
6.CONNECT TIE ROD END SUB-ASSEMBLY
89543
7.INSTALL FRONT SPEED SENSOR
43502H
8.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new front drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Using a 30 mm deep socket wrench, install the front axle shaft nut.
Keep depressing the brake pedal to prevent the drive shaft from rotating.
Using a chisel and a hammer, stake the front axle shaft nut.
9.ADD HYBRID TRANSAXLE FLUID
10.INSPECT HYBRID TRANSAXLE FLUID
11.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
12.INSTALL FRONT WHEELS
13.ADJUST FRONT WHEEL ALIGNMENT
51444A
14.INSTALL REAR ENGINE UNDER COVER LH
51443C
15.INSTALL REAR ENGINE UNDER COVER RH
51441
16.INSTALL NO. 1 ENGINE UNDER COVER
17.CHECK FOR SPEED SENSOR SIGNAL