Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT BUZZER(for LHD) › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0299674 DRIVING SUPPORT BUZZER(for LHD) A

CRUISE CONTROL  DRIVING SUPPORT BUZZER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist sensor system*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)


PROCEDURE

Hide 55545 1.REMOVE FUSE BOX OPENING COVER

Hide 86652E 2.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)

a.
E357139

Disengage the clamp.


b.

Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).

NOTICE:

If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.