Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › 2016.10–2019.09
RM32K0E _52 Drivetrain _061337 AXLE AND DIFFERENTIAL _0299680 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 42431 2.INSTALL REAR DISC

Hide 3.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 5.REMOVE REAR DISC

Hide 6.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 8.INSTALL REAR DISC

Hide 9.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 10.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the skid control sensor connector to the rear axle hub and bearing assembly.


Hide 11.INSTALL REAR WHEEL

Hide 12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the reservoir level switch connector.


b.

Connect the cable to the negative (-) auxiliary battery terminal.

Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION


c.

Turn the power switch on (READY).


d.

Depress the brake pedal and release it.