Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM32K0E _58 Vehicle Interior _061609 HEATING / AIR CONDITIONING _0300409 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for the LHD vehicles.



PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
I112854C02
2.521,2.333 2.271,2.583 true 2.688,2.333 2.875,2.563 true 2.406,0.677 2.083,0.417 true 2.938,0.448 2.729,0.688 false 2.146,2.583 2.354,2.802 0.208,0.219 10 true *a 2.792,2.583 2.99,2.781 0.198,0.198 10 true *b 0.854,2.51 1.063,2.729 0.208,0.219 10 false A 2.292,1.49 2.458,1.677 0.167,0.188 10 true B 1.948,0.302 2.125,0.49 0.177,0.188 10 false a 2.542,0.167 2.719,0.354 0.177,0.188 10 false x 2.99,0.333 3.167,0.521 0.177,0.188 10 false b
*a Fixed Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Part Length
A 50.0 mm (1.97 in.)
B 61.1 mm (2.41 in.)


NOTICE:
·

Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.

·

Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 88515 3.INSTALL COOLER EXPANSION VALVE

Hide 87107A 4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

Hide 87050C 7.INSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

Hide 82210K 8.INSTALL AIR CONDITIONING HARNESS ASSEMBLY