When the front doors are closed, each power window regulator motor assembly can be operated for approximately 45 seconds after the power switch is turned from on (IG) to off by receiving operation permission signals from the main body ECU (multiplex network body ECU). However, when approximately 45 seconds have elapsed, or the driver door or front passenger door is opened within approximately 45 seconds of the power switch being turned off, the power window regulator motor assemblies stop operating.
During auto operation, when 45 seconds have elapsed and key-off operation is prohibited, the power window stops immediately.
During an auto operation, when 45 seconds have elapsed and key-off operation is prohibited, the power window continues operating until the auto operation is completed.
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
Check that the manual up and down functions using the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH or RH door) can operate the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Manual up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Remote up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the key-off operation function.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
| Result | Proceed to |
|---|---|
| Power window can be operated even after opening driver door or front passenger door within approximately 45 seconds of power switch being turned off | A |
| Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for All Doors) (for LHD) | B |
| Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for All Doors) (for RHD) | C |
| Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for Driver Door or Front Passenger Door) | D |
| Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for Rear LH Door or Rear RH Door) | E |
A
B
C
D
E
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Door Courtesy SW | Front door courtesy light switch assembly (for RH) signal | OFF or ON | OFF: Front door RH closed
ON: Front door RH open |
- |
| FL Door Courtesy SW | Front door courtesy light switch assembly (for LH) signal | OFF or ON | OFF: Front door LH closed
ON: Front door LH open |
- |
| Tester Display |
|---|
| FR Door Courtesy SW |
| FL Door Courtesy SW |
On the GTS screen, ON or OFF is displayed accordingly.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C