If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.
Disconnect the F48 or F49 radio receiver assembly connectors.
Disconnect the I1 and J1 front No. 1 speaker assembly connectors.
Disconnect the F85 and F86 front No. 2 speaker assembly connectors.
Disconnect the K4 and L4 rear speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F48-1 (FR+) - F85-4 (TWR+) | Always | Below 1 Ω |
| F48-5 (FR-) - F85-2 (TWR-) | Always | Below 1 Ω |
| F85-3 (+) - I1-1 | Always | Below 1 Ω |
| F85-1 (-) - I1-2 | Always | Below 1 Ω |
| F48-2 (FL+) - F86-4 (TWL+) | Always | Below 1 Ω |
| F48-6 (FL-) - F86-2 (TWL-) | Always | Below 1 Ω |
| F86-3 (+) - J1-1 | Always | Below 1 Ω |
| F86-1 (-) - J1-2 | Always | Below 1 Ω |
| F49-1 (RR+) - K4-1 | Always | Below 1 Ω |
| F49-3 (RR-) - K4-2 | Always | Below 1 Ω |
| F49-2 (RL+) - L4-1 | Always | Below 1 Ω |
| F49-6 (RL-) - L4-2 | Always | Below 1 Ω |
| F48-1 (FR+) or F85-4 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F48-5 (FR-) or F85-2 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F85-3 (+) or I1-1 - Body ground | Always | 10 kΩ or higher |
| F85-1 (-) or I1-2 - Body ground | Always | 10 kΩ or higher |
| F48-2 (FL+) or F86-4 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F48-6 (FL-) or F86-2 (TWL-) - Body ground | Always | 10 kΩ or higher |
| F86-3 (+) or J1-1 - Body ground | Always | 10 kΩ or higher |
| F86-1 (-) or J1-2 - Body ground | Always | 10 kΩ or higher |
| F49-1 (RR+) or K4-1 - Body ground | Always | 10 kΩ or higher |
| F49-3 (RR-) or K4-2 - Body ground | Always | 10 kΩ or higher |
| F49-2 (RL+) or L4-1 - Body ground | Always | 10 kΩ or higher |
| F49-6 (RL-) or L4-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the malfunction disappears when a known good speaker is installed.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Malfunction disappears.
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG