The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lumbar support adjuster assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Lumbar support adjuster assembly is available only on the driver side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
72760D
2.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY
Disconnect the connector.
Disengage the clamp.
Disengage the claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this Direction |
Disengage the guides to remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.
Remove the 2 front seatback edge protectors from the lumbar support adjuster assembly.