The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat heater control sub-assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.REMOVE FRONT SEAT ASSEMBLY
87501B
2.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY
Disengage the claw to separate the seat heater control sub-assembly.
Disconnect the connector to remove the seat heater control sub-assembly.