Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061963 MIRROR (EXT) _0301956 POWER MIRROR CONTROL SYSTEM J

MIRROR (EXT)  POWER MIRROR CONTROL SYSTEM  Mirror Heater does not Operate with Rear Defogger Switch  


DESCRIPTION

When the mirror heater switch (rear window defogger switch) on the air conditioning control assembly is pressed, the operation signal is sent to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the defogger relay to operate the mirror heaters.

WIRING DIAGRAM

B462688E04
0.01,1.938 0.927,2.385 0.917,0.448 10 false from Auxiliary Battery 0.021,2.552 0.792,3.063 0.771,0.51 10 false from IG1-NO. 1 Relay 1.458,2.156 1.917,2.354 0.458,0.198 10 false DEF 1.135,2.76 3.125,2.958 1.99,0.198 10 false ECU-IG1 NO. 3 1.938,1.292 2.094,1.49 0.156,0.198 10 false 4 1.948,1.896 2.104,2.094 0.156,0.198 10 false 5 1.948,2.49 2.104,2.688 0.156,0.198 10 false 1 3.042,1.594 3.198,1.792 0.156,0.198 10 false 3 3.052,2.49 3.219,2.698 0.167,0.208 10 false 2 2.375,3.156 2.833,3.354 0.458,0.198 10 false DEF 3.24,1.906 4.313,2.104 1.073,0.198 10 false MIR HTR 4.365,0.635 4.521,0.833 0.156,0.198 10 false 8 4.365,2.885 4.521,3.083 0.156,0.198 10 false 8 4.563,0.625 4.719,0.823 0.156,0.198 10 false + 6.365,0.625 6.521,0.823 0.156,0.198 10 false - 6.521,0.635 6.833,0.833 0.313,0.198 10 false 9 5.042,1.094 6.146,1.396 1.104,0.302 10 false Outer Mirror LH 5.01,3.333 6.094,3.885 1.083,0.552 10 false Outer Mirror RH 4.448,1.448 4.906,1.646 0.458,0.198 10 false J7 4.406,1.625 6.781,2.073 2.375,0.448 10 false Outer Rear View Mirror Assembly LH 4.542,3.729 4.854,3.927 0.313,0.198 10 false I8 4.521,3.906 6.969,4.229 2.448,0.323 10 false Outer Rear View Mirror Assembly RH 4.208,5.167 4.365,5.365 0.156,0.198 10 false 5 4.156,5.885 4.469,6.083 0.313,0.198 10 false 14 5.698,5.969 5.854,6.167 0.156,0.198 10 false 4 2.438,5.865 2.594,6.063 0.156,0.198 10 false 2 4.469,5.313 5.083,5.51 0.615,0.198 10 false RDFG 2.063,6.063 2.677,6.26 0.615,0.198 10 false LIN1 5.313,6.063 5.771,6.26 0.458,0.198 10 false GND 4.469,6.094 5.083,6.292 0.615,0.198 10 false LIN1 0.917,6.479 1.375,6.677 0.458,0.198 10 false F61 0.906,6.635 3.156,6.979 2.25,0.344 10 false Air Conditioning Control Assembly 4.354,6.615 4.813,6.813 0.458,0.198 10 false F73 4.344,6.792 6.802,7.219 2.458,0.427 10 false Air Conditioning Amplifier Assembly 0.646,7.323 4.313,7.521 3.667,0.198 10 false : LIN Communication Line 6.542,2.885 6.854,3.083 0.313,0.198 10 false 9 6.375,2.875 6.531,3.073 0.156,0.198 10 false - 4.573,2.885 4.729,3.083 0.156,0.198 10 false +

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the auxiliary battery voltage is low, the mirror heater function may not operate. In this case, check the Data List item "Battery Control Count (Body ECU)".

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Defogger Relay (Rear) Mirror Heater OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Defogger Relay (Rear)
50004 121 22

Result:
Result Proceed to
Mirror heater operation on both mirrors is not normal A
Mirror heater operation on RH side mirror is not normal B
Mirror heater operation on LH side mirror is not normal C



A

2.CHECK WINDOW DEFOGGER SYSTEM

B

4.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY RH - BODY GROUND)

C

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY LH - BODY GROUND)
2.CHECK WINDOW DEFOGGER SYSTEM
a.

Check the window defogger system operation.

Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>OPERATION CHECK

OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY RH/LH - BODY GROUND)

NG

3.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY RH/LH - BODY GROUND)
a.

Remove the DEF relay from the No. 2 engine room relay block.


b.

Disconnect the I8 outer rear view mirror assembly RH connector.


c.

Disconnect the J7 outer rear view mirror assembly LH connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal-3 - I8-8 (+) Always Below 1 Ω
DEF relay holder terminal-3 - J7-8 (+) Always Below 1 Ω
DEF relay holder terminal-3 - Body Ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY RH - BODY GROUND)
a.

Remove the DEF relay from the No. 2 engine room relay block.


b.

Disconnect the I8 outer rear view mirror assembly RH connector.


c.

Disconnect the J7 outer rear view mirror assembly LH connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal-3 - I8-8 (+) Always Below 1 Ω
I8-9 (-) - Body Ground Always Below 1 Ω
I8-8 (+) - Body Ground Always 10 kΩ or higher
DEF relay holder terminal-3 - Body Ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.INSPECT OUTER MIRROR RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.INSPECT OUTER MIRROR RH

b.

Inspect the outer mirror RH.

Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION

OK:

Outer rear mirror RH is normal.



Result:
Proceed to
OK
NG



OK

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH

NG

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - OUTER REAR VIEW MIRROR ASSEMBLY LH - BODY GROUND)
a.

Remove the DEF relay from the No. 2 engine room relay block.


b.

Disconnect the J7 outer rear view mirror assembly LH connector.


c.

Disconnect the I8 outer rear view mirror assembly RH connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal-3 - J7-8 (+) Always Below 1 Ω
J7-9 (-) - Body Ground Always Below 1 Ω
J7-8 (+) - Body Ground Always 10 kΩ or higher
DEF relay holder terminal-3 - Body Ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.INSPECT OUTER MIRROR LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT OUTER MIRROR LH

b.

Inspect the outer mirror LH.

Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION

OK:

Outer rear mirror LH is normal.



Result:
Proceed to
OK
NG



OK

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH

NG