Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING › 2016.10–2019.09
RM32K0E _58 Vehicle Interior _062036 INTERIOR PANELS / TRIM _0302277 ROOF HEADLINING A

INTERIOR PANELS / TRIM  ROOF HEADLINING  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 63341 1.REMOVE NO. 1 ROOF SILENCER PAD (w/ Map Light)

a.

Remove the No. 1 roof silencer pad.

B461375


Hide 63387 2.REMOVE ROOF HEADLINING FORMING PAD (w/ Map Light)

a.

Remove the 2 roof headlining forming pads.

B461444


Hide 63342 3.REMOVE NO. 2 ROOF SILENCER PAD (w/ Map Light)

a.

Remove the 2 No. 2 roof silencer pads.

B461377


Hide 63341G 4.REMOVE ROOF SILENCER PAD (w/ Map Light)

a.

Remove the 2 roof silencer pads.

B461379


Hide 82171 5.REMOVE NO. 1 ROOF WIRE

a.

Disengage each guide.

B461381C01
0.156,0.146 0.531,0.385 0.375,0.24 12 false *A 0.167,1.417 0.542,1.656 0.375,0.24 12 false *B 0.167,1.625 0.542,1.865 0.375,0.24 12 false *C 3.333,0.354 3.646,0.594 0.313,0.24 12 true *D 4.708,2.146 5.021,2.385 0.313,0.24 12 true *E
*A w/ Vanity Light *B w/ Rain Sensor
*C w/ Lane Departure Alert System *D w/ Intrusion Sensor
*E w/ Map Light - -



b.

Peel off the pieces of each adhesive tape and remove the No. 1 roof wire.


c.
B461402C01
0,0 0,0 false
V113147

Remove in this Direction


w/ Vanity Light:

i.

Turn the visor connector approximately 90° counterclockwise and disconnect the visor connectors as shown in the illustration.

HINT:

Use the same procedures for the opposite side.




Hide 86101J 6.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

Hide 63323E 7.REMOVE HEADLINING LIGHT CASE (w/ Map Light)

a.

Remove the headlining light case.

B461394


Hide 63398 8.REMOVE ROOF HEADLINING SUPPORT PLATE (w/ Intrusion Sensor)

a.

Remove the roof headlining support plate.

B461395