Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _061817 AUDIO / VIDEO _0303537 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced the during antenna cord sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 55401E 1.REMOVE INSTRUMENT PANEL SAFETY PAD

Hide 55086 2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for LHD)

Hide 55084E 3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)

Hide 86101 4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)

a.

Disengage the clamps to remove the antenna cord sub-assembly.

E353801C01
3.479,0.979 3.76,0.51 true 1.896,0.885 2.344,1 true 2.823,1.719 2.896,1.427 true 4.135,1.417 3.854,1.583 true 3.771,0.323 4.146,0.563 0.375,0.24 12 false *A 1.656,0.688 2.031,0.927 0.375,0.24 12 false *B 2.677,1.75 3.052,1.99 0.375,0.24 12 false *A 4.198,1.271 4.448,1.51 0.25,0.24 12 true *A
*A w/ USB Audio System *B w/ Manual (SOS) Switch



b.

w/ Manual (SOS) Switch:

i.

Disconnect the connector.



Hide 86101 5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

Disengage the clamps to remove the antenna cord sub-assembly.

E353804C01
1.49,1.354 1.792,1.625 true 0.448,0.76 0.677,1.115 true 0.417,1.865 0.99,1.74 true 1.865,1.563 2.156,1.802 0.292,0.24 12 false *A 0.24,0.552 0.531,0.792 0.292,0.24 12 false *A 1.042,1.615 1.333,1.854 0.292,0.24 12 false *A
*A w/ USB Audio System - -



b.

w/ Navigation System:

i.

Disconnect the connector.



Hide 63311C 6.REMOVE ROOF HEADLINING

Hide 86101J 7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

Type A:

i.

Remove each adhesive tape from the roof headlining.

E359078C01
2.396,2.292 3.031,3.375 0.635,1.083 0.896,2.76 1.021,2.5 true 1.781,2.438 1.469,2.563 true 3.042,2.906 3.302,2.906 true 1.813,2.292 2.125,2.49 0.313,0.198 10 false *b 0.729,2.75 1.042,2.948 0.313,0.198 10 false *a 3.396,2.75 3.677,2.99 0.281,0.24 12 true *A
*A w/ Digital Audio Broadcasting Antenna - -
*a Notch *b Clamp
V100155

Adhesive Tape
V100136

Front



ii.

Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.



b.

Type B:

i.

Remove each adhesive tape from the roof headlining.

E353819C03
2.406,2.323 3.063,3.417 0.656,1.094 0.875,2.125 1.031,2.365 true 1.083,2.813 1.281,2.594 true 3.063,2.885 3.344,2.885 true 0.708,1.979 0.906,2.177 0.198,0.198 10 true *a 0.896,2.708 1.094,2.906 0.198,0.198 10 true *b 3.406,2.771 3.729,3.021 0.323,0.25 12 true *A
*A w/ Digital Audio Broadcasting Antenna - -
*a Notch *b Clamp
V100155

Adhesive Tape
V100136

Front



ii.

Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.



Hide 86101R 8.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Digital Audio Broadcasting Antenna)

a.
E353808

Disconnect the connector.


b.

Disengage the clamp to remove the No. 5 antenna cord sub-assembly.


Hide 86101D 9.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY

a.

w/o FM Sub-antenna:

i.
E353809

Disconnect the connector.


ii.

Disengage the clamps.


iii.
E353810C01
0.688,1.323 1.063,1.406 true 2.292,0.771 2.552,0.594 true 0.417,1.208 0.656,1.417 0.24,0.208 10 true *b 2.594,0.417 2.833,0.625 0.24,0.208 10 true *a
*a Guide
*b Clamp


Remove the bolt.


iv.

Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.



b.

w/ FM Sub-antenna:

i.
E353812

Disconnect the connector of the No. 4 antenna cord sub-assembly.


ii.
E353809

Disconnect the connector.


iii.

Disengage the clamps.


iv.
E353811C01
2.115,0.833 2.448,0.833 true 1.104,1.5 0.771,1.5 true 2.521,0.719 2.76,0.917 0.24,0.198 10 true *a 0.438,1.396 0.677,1.594 0.24,0.198 10 true *b
*a Guide
*b Clamp


Disconnect the connector of the floor wire.


v.

Remove the bolt.


vi.

Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.



Hide 64790B 10.REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY (w/ FM Sub-antenna)

Hide 86101Q 11.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY (w/ FM Sub-antenna)

a.
E353813

Disconnect the connector.


b.

Disengage the clamp and 2 grommets to remove the No. 4 antenna cord sub-assembly.