Use the same procedure for LHD and RHD vehicles.
The procedure described below is for the LHD vehicles.
Use the same procedure as for the LH and RH sides.
The procedure described below is for the LH side.
74232
1.REMOVE FRONT ARMREST BASE UPPER PANEL (for Driver Side)
74232
2.REMOVE FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
69284C
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
67602
4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
81080S
5.REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
| *a | Clamp |
| *b | Guide |
Using a clip remover, disengage the clamp and guides to disconnect the wire harness.
Remove the 2 screws.
Disengage the claws to remove the No. 1 interior illumination light assembly.