Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
67408F
4.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
68152C
5.INSTALL REAR DOOR GLASS RUN
67674A
6.INSTALL REAR DOOR FRAME GARNISH
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER
68199
8.INSTALL REAR DOOR BELT REAR SEAL
68197
9.INSTALL REAR DOOR BELT SEAL
67498
10.INSTALL REAR DOOR GLASS INNER WEATHERSTRIP
67604
11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
67498
12.INSTALL REAR DOOR REAR FRAME BRACKET
84810D
13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
69284D
14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
15.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
16.INITIALIZE POWER WINDOW CONTROL SYSTEM
17.INSPECT POWER WINDOW OPERATION