Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2016.10–2019.09
RM32K0E _V1 General _059400 INTRODUCTION _0290785 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

NOTICE:
·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Audio and Visual System).

·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Navigation System (for Radio and Display Type)).




PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures not Performed Link
for SFI system

ECM


Perform Vehicle Identification Number (VIN) registration MIL comes on (Click here)
for SFI system
·

Throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

EGR valve assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


(Click here)
Hybrid vehicle transaxle assembly
·

Resolver learning

·

Initialize resolver


HV battery Battery status info update HV battery status information cannot be updated (Click here)
Hybrid battery terminal block Perform high voltage fuse accumulated load history reset DTCs are stored
Millimeter wave radar sensor assembly*2 Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Pre-crash safety system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control)

·

Road sign assist system


(Click here)
·

Forward recognition camera*2

·

Windshield glass*2


Adjust forward recognition camera
·

Dynamic radar cruise control system

·

Lane departure alert system (w/ Steering Control)

·

Pre-crash safety system

·

Forward recognition camera system

·

Automatic high beam system


(Click here)
·

Tire pressure warning ECU and receiver (Electrical key and tire pressure monitoring system receiver assembly)

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Registration:(Click here)
for Initialization:(Click here)
·

Skid control ECU (Brake booster with master cylinder assembly)

·

Brake actuator assembly


1.

Bleed air

2.

Clear the data stored during previous linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.

3.

Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light / yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


for Initialization:(Click here)
for Calibration:(Click here)
·

Brake pedal stroke sensor assembly

·

Brake pedal


1.

Clear the data stored during previous linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.

2.

Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.


·

Skid control ECU (Brake booster with master cylinder assembly)

·

Yaw rate and acceleration sensor (Airbag ECU assembly)


1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


Parking Brake ECU assembly Operate the electric parking brake switch assembly Parking brake indicator light (red) blinks when the power switch is first turned on (IG) (Click here)
Power steering ECU assembly
·

Torque sensor zero point calibration

·

Assist map writing


·

DTCs are stored

·

EPS warning light illuminates


(Click here)
Electric power steering column sub-assembly Torque sensor zero point calibration
Steering sensor Steering angle neutral point (Initialize panoramic view monitor system) Simple Intelligent Parking Assist System (Click here)
Toyota parking assist-sensor system
Clearance warning ECU assembly
·

Steering angle neutral point

·

Registration of bumper type


·

Simple Intelligent Parking Assist System

·

Toyota parking assist-sensor system


(Click here)
Blind spot monitor sensor Blind spot monitor beam axis adjustment DTCs are output (Click here)
·

Certification ECU (smart key ECU assembly)

·

ID code box (immobiliser code ECU)

·

Steering lock ECU (steering lock actuator)

·

Electrical key transmitter sub-assembly

·

Main body ECU (multiplex network body ECU)


Perform code registration (Immobiliser system)
·

Entry and start system

·

Wireless door lock control system

·

Hybrid control system cannot be started

·

Steering lock system


See Service Bulletin for the registration method.
Hybrid vehicle control ECU Perform code registration (Immobiliser system)
·

Entry and start system

·

Wireless door lock control system

·

Hybrid control system cannot be started


·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly

·

Air conditioning amplifier assembly


Initialize servo motor (Air conditioning system) DTCs are stored (Click here)
·

Door window regulator assembly

·

Power window regulator motor assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)
·

Rear height control sensor sub-assembly LH

·

Suspension, tires, etc.*1


Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


·

Swing grille actuator assembly*3

·

Radiator shutter sub-assembly*3


Change grille shutter control modes and/or perform initialization Grille shutter system (Click here)


*1: The vehicle height changes because of suspension or tire replacement.

*2: w/ Pre-collision System

*3: w/ Grille shutter System