The headlight ECU sub-assembly LH receives signals indicating the vehicle speed signal from the brake booster with master cylinder assembly (skid control ECU) using CAN communication. The headlight ECU sub-assembly LH stores DTC B2415.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2415 | Vehicle Speed Sensor Malfunction | Malfunction in vehicle speed signal | ·
Headlight ECU sub-assembly LH ·
Brake booster with master cylinder assembly (skid control ECU) |
- |
Confirm that there are no CAN communication system malfunctions before performing the following inspection.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
DTC B2415 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check for DTCs.
Electronically controlled brake system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG