Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ECU › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0304285 HEADLIGHT ECU A

LIGHTING (EXT)  HEADLIGHT ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced the during headlight ECU sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

NOTICE:

If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E351180

Remove the 3 screws.


b.
E351181

Separate the connector cover from the headlight ECU sub-assembly.


c.
E351182

Disconnect the connector to remove the headlight ECU sub-assembly.

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.



Hide 81134 3.REMOVE HEADLIGHT GASKET

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E351183

Remove the headlight gasket.