Home › Vehicle Exterior › HORN › HORN › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061788 HORN _0303186 HORN A

HORN  HORN  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the low pitched horn removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Front bumper assembly Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 53117C 2.REMOVE NO.1 RADIATOR GRILLE RETAINER

Hide 16561C 3.REMOVE NO.1 RADIATOR TO SUPPORT SEAL

Hide 86520 4.REMOVE LOW PITCHED HORN ASSEMBLY

a.
E357785

Disconnect the connector.


b.

Remove the bolt and low pitched horn assembly.