When the IPA main switch assembly is turned on, a signal is sent to the clearance warning ECU assembly. The simple intelligent parking assist system operates according to this signal.
Remove the IPA main switch assembly.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MAIN SWITCH>REMOVAL
Inspect the IPA main switch assembly.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MAIN SWITCH>INSPECTION
IPA main switch assembly is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F28 IPA main switch assembly connector.
Disconnect the F38 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F28-6 (IG) - F38-9 (R3) | Always | Below 1 Ω |
| F28-6 (IG) - Body ground | Always | 10 kΩ or higher |
| F28-3 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG