The clearance warning ECU assembly communicates with the yaw rate and acceleration sensor (airbag sensor assembly) circuit via CAN communication, and if it is determined that the yaw rate and acceleration sensor (airbag sensor assembly) is malfunctioning, DTC C1647 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1647 | G Sensor Failure | Yaw rate and acceleration sensor (airbag sensor assembly) malfunction | Electronically controlled brake system |
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.
Using the GTS, check for DTCs according to the prompts on the screen.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
DTC C1647 is stored when a malfunction signal sent from the electronically controlled brake system is detected.
If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1647 will not be output again.
If DTC C1647 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| DTC C1647 is output | A |
| DTC C1647 is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING