The headlight ECU sub-assembly LH stores this DTC when the headlight ECU sub-assembly RH detects an internal malfunction or if a communication malfunction occurs between headlight ECU sub-assembly LH and headlight ECU sub-assembly RH for 10 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0242 | Lost Communication With Headlamp Control Module "B" | Any of the following conditions is met:
·
Headlight ECU sub-assembly RH internal malfunction ·
Communication malfunction occurs between headlight ECU sub-assembly LH and headlight ECU sub-assembly RH for 10 seconds or more |
·
Headlight ECU sub-assembly LH ·
Headlight ECU sub-assembly RH ·
Harness or connector |
- |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | Power switch on (IG) | ○ | ○ |
| Malfunction Status | Headlight ECU sub-assembly RH internal malfunction | ○ | - |
| Communication malfunction occurs between headlight ECU sub-assembly LH and headlight ECU sub-assembly RH | - | ○ | |
| Detection Time | - | 10 seconds or more | |
| Number of Trips | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC U0242 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the A16 headlight ECU sub-assembly LH connector.
Disconnect the A17 headlight ECU sub-assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A16-20 (LINL) - A17-20 (LINL) | Always | Below 1 Ω |
| A16-20 (LINL) or A17-20 (LINL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight ECU sub-assembly RH with a new or known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC U0242 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG