This DTC is output if the vehicle variation information is not written to the headlight ECU sub-assembly LH.
The headlight ECU sub-assembly LH outputs DTC B2451.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2451 | Vehicle Specifications have not been Stored | Vehicle specification information not written | Headlight ECU sub-assembly LH | - |
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Before replacing the ECM or main body ECU (multiplex network body ECU), refer to Service Bulletin.
Register vehicle information for the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch to on (IG).
Turn on the headlights using the light control switch.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B2451 output does not occur | A |
| DTC B2451 output occurs | B |
A
B