Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY › 2016.10–2019.09
RM32K0E _58 Vehicle Interior _062267 SUPPLEMENTAL RESTRAINT SYSTEMS _0303873 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 73997 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG DOOR

a.
B460341

Engage the hooks.


b.
B460342

Engage the hooks to install the lower No. 1 instrument panel airbag door to the lower No. 1 instrument panel airbag assembly.


Hide 73900 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR

a.

Check that the power switch off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B454050C02
2.104,1.146 2.417,0.865 true 0.552,2.354 0.938,2.448 true 1.927,1.135 2.24,1.333 0.313,0.198 10 false *b 0.365,2.219 0.677,2.417 0.313,0.198 10 false *a
*a Airbag Connector
*b Airbag Connector Lock


Connect the airbag connector to the lower No. 1 instrument panel airbag assembly with door.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the airbag connector lock to install the airbag connector.

NOTICE:

Securely lock the airbag connector lock.



e.
B454046

Engage the hooks to temporarily install the lower No. 1 instrument panel airbag assembly with door.


f.

Install the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly with door is installed securely without any excessive gaps and is not protruding outward.



Hide 55434B 3.INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL

Hide 55470 4.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Hide 55545 5.INSTALL FUSE BOX OPENING COVER

Hide 6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION