The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat inner belt assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.REMOVE FRONT SEAT ASSEMBLY
73240
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
Disengage the clamp and claw.
w/ Vertical Adjuster:
Disengage the clamps.
Remove the nut and front seat inner belt assembly.
w/o Vertical Adjuster:
Disengage the clamp.
Remove the nut and front seat inner belt assembly.
Remove the front seat belt anchor plate.
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
Disconnect the connector.
Disengage the clamps and claw.
Disengage the clamp.
Remove the nut and front seat inner belt assembly.
Remove the front seat belt anchor plate.