Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304176 GRILLE SHUTTER A

EXTERIOR PANELS / TRIM  GRILLE SHUTTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the grille shutter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)
·

Swing grille actuator assembly

·

Radiator shutter sub-assembly


Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 52611 2.REMOVE FRONT BUMPER ENERGY ABSORBER

Hide 52618 3.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 53398A 5.REMOVE RADIATOR LOWER SEAL LH

a.
B458826C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the No. 1 radiator air guide LH as shown in the illustration.


Hide 53398A 6.REMOVE RADIATOR LOWER SEAL RH

a.
B458827C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the No. 1 radiator air guide RH as shown in the illustration.


Hide 53019B 7.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY

a.
B458828

Disconnect the connector.


b.

Disengage the clamp.


c.
B458829

Remove the 3 bolts.


d.
B458830C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides to remove the radiator shutter sub-assembly as shown in the illustration.