Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WINDSHIELD OUTSIDE MOULDING
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304184 WINDSHIELD OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  WINDSHIELD OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75547C 1.INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

HINT:

Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.


a.
B458728

Using a riveter with a nose piece, install 5 new No. 3 windshield outside moulding clips.

HINT:

If the mandrel of the No. 3 windshield outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.


NOTICE:
B398365C01
1.75,0.75 1.5,0.25 1.5,0.25 1.333,0.25 false 1.833,1.833 2.021,1.333 false 1.156,0.156 1.469,0.313 0.313,0.156 10 false *a 1.76,1.844 2.073,2 0.313,0.156 10 false *b 2.167,0.167 2.479,0.323 0.313,0.156 10 false *c
*a Riveter
*b Mandrel
*c Incorrect


·

Do not pry the No. 3 windshield outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.


·
B398364C01
1.031,0.333 1.281,0.333 false 1.083,1.396 1.333,1.396 false 1.313,0.26 1.625,0.417 0.313,0.156 10 false *a 1.938,0.094 2.25,0.25 0.313,0.156 10 false *b 1.375,1.313 1.688,1.469 0.313,0.156 10 false *a 1.938,1.167 2.25,1.323 0.313,0.156 10 false *b
*a Riveter
*b Incorrect


Confirm that the No. 3 windshield outside moulding clips are seated properly against the vehicle body.


·

Do not tilt the riveter when installing the No. 3 windshield outside moulding clip to the vehicle body.




b.

Install the windshield glass sub-assembly.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD GLASS>INSTALLATION


Hide 75545B 2.INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

HINT:

Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


a.

Engage the claws to install 5 new No. 1 windshield outside moulding clips as shown in the illustration.

B458729C01
0,0 0,0 false
V113147

Install in this Direction - -



Hide 75534 3.INSTALL WINDSHIELD OUTSIDE MOULDING

a.
B458730

Engage the claws to install the windshield outside moulding.


b.
B458731C01
0,0 0,0 false
V113147

Install in this Direction


Engage the clip and claws to connect the windshield outside moulding as shown in the illustration.


c.

Remove the protective tape.