The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the headlight assembly removal/installation are shown below.
If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT BUMPER ASSEMBLY
85319A
2.SEPARATE INLET HOSE (for RH Side)
Remove the clip to separate the inlet hose.
3.REMOVE HEADLIGHT ASSEMBLY
|
Protective Tape |
Apply protective tape around the headlight assembly as shown in the illustration.
| *a | Connector Lock Lever |
|
Remove in this Direction |
Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector.
Remove the bolt and 3 screws.
|
Remove in this Direction |
Remove the headlight assembly as shown in the illustration.