Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
69730E
1.INSTALL NO. 1 REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Engage the guide to install the No. 1 rear door lock remote control cable assembly to the rear door lock with motor assembly.
|
Install in this Direction |
Engage the claws as shown in the illustration.
69780B
2.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
w/o Double Locking System:
Engage the guide to install the rear door inside locking cable assembly to the rear door lock with motor assembly.
|
Install in this Direction |
Engage the claws as shown in the illustration.
w/ Double Locking System:
Engage the guide to install the rear door inside locking cable assembly to the rear door lock with motor assembly.
|
Install in this Direction |
Engage the claws as shown in the illustration.
69740D
3.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
w/ Double Locking System:
Engage the guide to install the rear door lock remote control cable assembly to the rear door lock with motor assembly.
|
Install in this Direction |
Engage the claw as shown in the illustration.
w/ Double Locking System:
Engage the guide to install the rear door lock remote control cable assembly to the rear door lock with motor assembly.
|
Install in this Direction |
Engage the claw as shown in the illustration.
69060A
4.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY
When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.
Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.
Apply MP grease to the sliding parts of the rear door lock with motor assembly.
When reusing the rear door lock with motor assembly:
Install a new door lock wiring harness seal to the rear door lock with motor assembly.
|
Install in this Direction |
Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.
Connect the connector.
69240
5.INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY
69227L
6.INSTALL REAR DOOR OUTSIDE HANDLE COVER
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER
67628
8.INSTALL REAR DOOR TRIM BRACKET
67604
9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
84810D
10.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
69284D
11.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
67498
12.INSTALL REAR DOOR REAR FRAME BRACKET
13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
14. INITIALIZE POWER WINDOW CONTROL SYSTEM
15.INSPECT POWER WINDOW OPERATION