This DTC is stored when the electronically controlled brake system has a problem. Check the electronically controlled brake system when DTC P157800 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P157800 | Brake System | When the power switch is on (IG) and the cruise control system is operating, a malfunction in the electronically controlled brake system is detected for 0.2 seconds or more. | ·
Electronically controlled brake system ·
Hybrid vehicle control ECU ·
Skid control ECU (Brake booster with master cylinder assembly) |
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Check for DTCs.
Electronically controlled brake system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF button).
Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
DTC P157800 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Replace the hybrid vehicle control ECU.
Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF button).
Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
DTC P157800 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG