When the dynamic radar cruise control system is turned on using the cruise control main switch (ON/OFF button), the cruise control indicator (vehicle-to-vehicle distance control mode) illuminates. The hybrid vehicle control ECU uses this and other indicators to indicate the control condition (presence or absence of a preceding vehicle, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state via CAN communication.
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF, 6 to 0 or All | - |
| Tester Display |
|---|
| Meter Display 1 |
| Result | Proceed to |
|---|---|
| The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. | A |
| The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Cruise Ready Main-CPU | Cruise control system standby condition | ON or OFF | Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes | - |
| Cruise Ready Sub-CPU | Cruise control system standby condition | ON or OFF | Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes | - |
| Cruise Indicator | Cruise control indicator status | ON or OFF | ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off |
- |
| Tester Display |
|---|
| Cruise Ready Main-CPU |
| Cruise Ready Sub-CPU |
| Cruise Indicator |
| Result | Proceed to |
|---|---|
| The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON/OFF button). | A |
| The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON/OFF button). | B |
| The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON/OFF button). | C |
A
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE
B
C