Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID VEHICLE CONTROL ECU › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _059620 HYBRID / BATTERY CONTROL _0292489 HYBRID VEHICLE CONTROL ECU A

HYBRID / BATTERY CONTROL  HYBRID VEHICLE CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Replacement of hybrid vehicle control ECU Perform code registration (Immobiliser system)
·

Entry and start system

·

Wireless door lock control system

·

Hybrid control system cannot be started


See Service Bulletin for the registration method.

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82877 3.REMOVE ECU INTEGRATION BOX RH (for LHD)

Hide 82878 4.REMOVE ECU INTEGRATION BOX LH (for RHD)

Hide 89981 5.REMOVE HYBRID VEHICLE CONTROL ECU (for LHD)

a.
A391951

Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box RH.

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.




Hide 89981 6.REMOVE HYBRID VEHICLE CONTROL ECU (for RHD)

a.
A391952

Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box LH.

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.