Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR › from 2018.05
RM32K0E _54 Brake _060048 PARKING BRAKE _0294936 ELECTRIC PARKING BRAKE ACTUATOR A

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 2.RELEASE PARKING BRAKE

a.

Move the shift lever to P.


b.

Turn the power switch on (IG).


c.

Operate the electric parking brake switch assembly to release the parking brake.

HINT:

If the parking brake cannot be released:

Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD



d.

Turn the engine switch off.


Hide 3.REMOVE REAR WHEEL

Hide 890C0A 4.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.
C399528

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

NOTICE:
·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.




Hide 46310B 5.REMOVE PARKING BRAKE ACTUATOR ASSEMBLY

a.
C399538

Using a 5 mm hexagon socket wrench, remove the 2 bolts and parking brake actuator assembly from the rear disc brake cylinder assembly.

NOTICE:
·

Check that there are no brake fluid leaks from the back of the rear disc brake cylinder assembly.

·

If there are any brake fluid leaks, replace the rear disc brake cylinder assembly.




b.

Remove the O-ring from the rear disc brake cylinder assembly.