Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2018.05–2019.09
RM32K0E _54 Brake _060048 PARKING BRAKE _0296497 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  C13AE  System information not received  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C13AE System information not received Both of following conditions are met:
1.

Power switch on (IG)

2.

When power switch is first turned on (IG) after parking brake ECU (brake actuator assembly) has been replaced, system cannot communicate with hybrid vehicle control ECU for approximately 4 seconds


·

Hybrid vehicle control ECU

·

CAN communication system

·

Parking brake ECU (brake actuator assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the parking brake ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light blinks (red) when the power switch is first turned on (IG).


PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Check for DTC.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > Electric Parking Brake > Trouble Codes
50001 184
Result:
Result Proceed to
DTC C13AE and a CAN DTC are output at the same time A
DTC C13AE is output and the MIL is illuminated B
Only DTC C13AE is output (for LHD) C
Only DTC C13AE is output (for RHD) D
DTCs are not output E




A

B

C

REPLACE PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY)

D

REPLACE PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY)

E