| Hybrid Battery Pack Sensor Module Mismatch
|
Displays if the wrong type of battery voltage sensor is installed.
|
( )
|
| Hybrid Battery Cooling Performance Decrement
|
History of poor HV battery cooling performance
|
( )
|
| Shift R/D/B(S) Operation during Ready OFF
|
History of attempts to change shift state to reverse (R), drive (D) or B with power switch on (IG)
|
-
|
| Shift D Operation during Backward Movement
|
History of attempts to change shift state to drive (D) while backing up
|
-
|
| Shift R Operation during Forward Movement
|
History of attempts to change shift state to reverse (R) while driving forward
|
-
|
| Shift R/D Operation during Ready OFF
|
History of shift state being changed to neutral (N) due to shift lever being held in R or D with power switch on (IG)
|
-
|
| Shift Position Uncertain
|
Shift position cannot be determined
|
-
|
| Quick Shift Operation to Shift Position N during Running
|
History of shift state being changed to neutral (N) while driving, without shift lever being held in N for a short time
|
-
|
| HV System Start Up Failure by Very Low Temperature
|
History of hybrid control system starting failure due to extremely cold environment
|
-
|
| HV System Start Up Failure by Immobiliser Unmatch
|
History of hybrid control system starting failure due to immobiliser system key verification failure
|
-
|
| Ready ON Failure by Shift Operation
|
History of READY ON failure due to shift operation
|
-
|
| Auxiliary Battery Voltage Low (HV)
|
History of drop in hybrid vehicle control ECU power source voltage
|
Stored when the auxiliary battery voltage to the hybrid control ECU drops below 9.5 V.
|
| Auxiliary Battery Voltage Low (Inverter)
|
History of drop in motor generator control ECU (MG ECU) power source voltage
|
Stored when the auxiliary battery voltage to the motor generator control ECU (MG ECU) drops to 8.0 V or less.
|
| HV System Stop Operation during Running
|
History of hybrid control system being turned off by pressing power switch while vehicle being driven
|
Stored when the power switch is turned off when the vehicle speed is 3 km/h (2 mph) or more.
|
| Generator Temperature High
|
History of extremely high generator (MG1) temperature and hybrid system overheated warning message being displayed
|
Stored when the generator (MG1) temperature exceeds a specified value.
|
| Generator Inverter Temperature High
|
History of extremely high generator (MG1) inverter temperature and hybrid system overheated warning message being displayed
|
Stored when the generator (MG1) inverter temperature exceeds a specified value.
|
| Motor Temperature High
|
History of extremely high motor (MG2) temperature and hybrid system overheated warning message being displayed
|
-
|
| Motor Inverter Temperature High
|
History of extremely high motor (MG2) inverter temperature and hybrid system overheated warning message being displayed
|
Stored when the motor (MG2) inverter temperature exceeds a specified value.
|
| Boosting Converter Temperature High
|
History of extremely high boost converter temperature and hybrid system overheated warning message being displayed
|
-
|
| Staying Prevention Control
|
History of operation of retention prevention function
|
Stored when the engine speed remains in the resonance range.
|
| Hybrid Battery Protection in Neutral Shift Position
|
History of hybrid battery discharge warning message being displayed when vehicle left with shift lever in N
|
-
|
| HV Coolant Temperature High
|
History of extremely high coolant (for inverter) temperature
|
Stored when the coolant (for inverter) temperature is 65°C or more.
|
| Hybrid Battery Voltage Low
|
History of hybrid control system starting failure due to low HV battery voltage
|
-
|
| HV System Start Up Failure by Hybrid Battery Unmatch
|
History of hybrid control system starting failure due to an inappropriate HV battery
|
-
|
| Engine Malfunction (Poor Engine Power)
|
History of vehicle state during engine malfunction (poor engine power)
(This information can be helpful for performing troubleshooting.)
|
Stored when the ECM stores an SFI system DTC.
Make sure to clear Vehicle Control History after performing troubleshooting related to this item.
As all Vehicle Control History should be cleared after performing troubleshooting related this item, make sure to check any other output Vehicle Control History items and perform any troubleshooting for them before clearing Vehicle Control History.
|
| Engine Malfunction (Engine does not Start)
|
History of vehicle state during engine malfunction (engine does not start)
(This information can be helpful for performing troubleshooting.)
|
Stored when the ECM stores an SFI system DTC.
Make sure to clear Vehicle Control History after performing troubleshooting related to this item.
As all Vehicle Control History should be cleared after performing troubleshooting related this item, make sure to check any other output Vehicle Control History items and perform any troubleshooting for them before clearing Vehicle Control History.
|
| Engine Malfunction (Crankshaft Position Sensor Signal)
|
History of vehicle state during engine malfunction (abnormal crankshaft position sensor signal)
(This information can be helpful for performing troubleshooting.)
|
Stored when the ECM stores an SFI system DTC.
Make sure to clear Vehicle Control History after performing troubleshooting related to this item.
As all Vehicle Control History should be cleared after performing troubleshooting related this item, make sure to check any other output Vehicle Control History items and perform any troubleshooting for them before clearing Vehicle Control History.
|
| Engine Malfunction (GO Signal)
|
History of vehicle state during engine malfunction (GO signal)
(This information can be helpful for performing troubleshooting.)
|
Stored when the ECM stores an SFI system DTC.
Make sure to clear Vehicle Control History after performing troubleshooting related to this item.
As all Vehicle Control History should be cleared after performing troubleshooting related this item, make sure to check any other output Vehicle Control History items and perform any troubleshooting for them before clearing Vehicle Control History.
|
| Engine Malfunction (Component Malfunction)
|
History of vehicle state during engine malfunction (engine component malfunction)
(This information can be helpful for performing troubleshooting.)
|
Stored when the ECM stores an SFI system DTC.
Make sure to clear Vehicle Control History after performing troubleshooting related to this item.
As all Vehicle Control History should be cleared after performing troubleshooting related this item, make sure to check any other output Vehicle Control History items and perform any troubleshooting for them before clearing Vehicle Control History.
|
| Driver Exited Vehicle when Shift Position Wasn't P
|
History of vehicle speed exceeding threshold after driver left vehicle with shift position other than shift lever in P
|
-
|
| Accelerator Depress when Shift P Position during Ready ON
|
History of accelerator pedal depressed in P position when power switch on (READY)
|
-
|
| Limit to Charge / Discharge Control Value by Hybrid Battery Temperature High
|
History of HV battery charge/discharge being restricted If the temperature of the HV battery becomes approximately 44°C (111.2°F) or higher due to high ambient temperature, high cabin temperature, continuous driving under high load (such as mountain driving or frequent acceleration/deceleration), clogged hybrid battery intake duct, etc., the HV battery current will be restricted In this case the value of WIN/WOUT will decrease and the engine will stop and start less frequently.
|
1.
If this Vehicle Control History item is stored, perform the following inspections.
-
Check the Vehicle Control History freeze frame data.
-
Check for clogs in the hybrid battery intake duct.
-
Inspect the HV battery cooling filter.
( )
-
Check the intake port of the HV battery cooling system for blockage, such as luggage, etc.
2.
After performing the above inspections, check the temperature of the HV battery in the Data List.
If the temperature of the HV battery is high (approximately 44°C (111.2°F) or higher), stop the vehicle, turn the air conditioning system on (Temperature: Lo, Blower speed: Max)
|
| Limit to Charge / Discharge Control Value by Hybrid Battery
|
Indicates whether Win/Wout is restricted due to causes other than HV battery temperature.
|
-
|
| Auxiliary Battery Voltage Low at Start
|
History of low auxiliary battery voltage at hybrid control system start
|
-
|
| Auxiliary Battery Voltage Low at IG OFF
|
History of low auxiliary battery voltage when power switch off
|
-
|
| Auxiliary Battery Discharge at IG OFF
|
History of auxiliary battery becoming discharged when power switch off
|
-
|
| Auxiliary Battery Discharge at Running
|
History of auxiliary battery becoming discharged while vehicle being driven
|
-
|