*1: Check vehicle control history (wrong assembly confirmation)
Using the GTS, check the vehicle control history.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>VEHICLE CONTROL HISTORY
If "Hybrid Battery Pack Sensor Module Mismatch" is displayed, the wrong type of battery voltage sensor is installed.
If the battery voltage sensor had been replaced just before the malfunction occurred, check the part number of the battery voltage sensor.
The type of battery voltage sensor to be used varies depending on the vehicle model.
If the wrong type of battery voltage sensor is installed, the power switch cannot be turned on (READY).
After installing the battery voltage sensor, perform the following to check that the power switch can be turned on (READY).
Turn the power switch on (READY).
Turn the power switch off and wait for 2 minutes or more.
Turn the power switch on (READY) again.
*2: If the battery cooling blower assembly malfunctions, DTC P0A8111, P0A8115 or P0A8196 will be stored. If only "Maintenance Required for Hybrid Battery Cooling Parts at Your Dealer" is displayed on the multi-information display, only perform the inspection of the HV battery cooling system intake port, filter and duct.
*3: If any of the following Diagnosis Related Information items are output, perform troubleshooting for the corresponding DTCs.
| Result | Link | |
|---|---|---|
| Hybrid control system | P312387 | ( )
|
| Motor generator control system | P31241F | ( )
|
| P312487 | ||