Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE › from 2019.09
RM32K0E _58 Vehicle Interior _061609 HEATING / AIR CONDITIONING _0300401 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PIPING CLAMP (for Suction Hose Sub-assembly)

a.

Remove the vinyl tape from the open ends of the suction pipe sub-assembly and suction hose sub-assembly.


b.
E338279C02
0.75,1.885 0.75,1.552 false 1.938,0.51 2.198,0.198 false 1.427,0.51 1.688,0.198 false 0.698,1.906 1.01,2.063 0.313,0.156 10 false *1 2.229,0.125 2.542,0.281 0.313,0.156 10 false *2 1.74,0.125 2.052,0.281 0.313,0.156 10 false *a
*1 Suction Hose Sub-assembly
*2 Piping Clamp
*a Groove


Install a new piping clamp to the suction hose sub-assembly.

NOTICE:
·

Securely engage the inside step of the piping clamp in the suction hose sub-assembly groove.

·

Do not widen the opening of the piping clamp more than the diameter of the suction hose sub-assembly when installing it.

·

Do not install the piping clamp with the large diameter section in the wrong direction.




c.

Thoroughly coat 2 new O-rings and contact surface of the suction hose sub-assembly with compressor oil.

Compressor Oil:

ND-OIL 11 or equivalent



d.

Install the 2 O-rings to the suction hose sub-assembly.

NOTICE:

Do not let foreign matter adhere to the O-rings or O-ring seals.



e.
E338280C02
0.198,0.958 0.646,0.542 0.646,0.542 0.198,1.25 true 2.552,0.906 3,0.49 3,0.49 2.531,1.302 true 0.865,1.021 1.042,1.177 0.177,0.156 10 true *a 0.688,0.479 1,0.635 0.313,0.156 10 false *b 3.042,0.438 3.354,0.594 0.313,0.156 10 false *b
*a Large Diameter Section of Piping Clamp
*b Alignment Mark


Engage the suction pipe sub-assembly and suction hose sub-assembly by matching the alignment marks.

NOTICE:

Engage the parts by holding the pipe, not the piping clamp.



f.
E338281C02
1.479,1.802 1.479,1.385 true 1.406,1.823 1.719,1.979 0.313,0.156 10 false *a
*a Large Diameter Section of Piping Clamp


Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly.

HINT:
·

When inserting, make sure that a click sound is heard.

·

Check that the suction hose sub-assembly is securely inserted by pulling it.




Hide 2.INSTALL PIPING CLAMP (for Cooler Refrigerant Liquid Pipe A)

Hide 3. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT