88460
1.INSTALL COOLER CONDENSER ASSEMBLY
|
Install in this Direction |
Engage the 2 guides and 2 claws to install the cooler condenser assembly as shown in the illustration.
Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly.
If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.
Add 40 cc (1.35 fl. oz)
ND-OIL 11 or equivalent
88716A
2.CONNECT COOLER REFRIGERANT LIQUID PIPE A
Remove the vinyl tape from the open ends of the cooler condenser assembly and cooler refrigerant liquid pipe A.
| *1 | Air Conditioner Tube and Accessory Assembly |
| *2 | Piping Clamp |
| *a | Groove |
Install a new piping clamp to the cooler refrigerant liquid pipe A.
Securely engage the inside step of the piping clamp in the cooler refrigerant liquid pipe A groove.
Do not widen the opening of the piping clamp more than the diameter of the suction pipe sub-assembly when installing it.
Do not install the piping clamp with the large diameter section in the wrong direction.
Thoroughly coat 2 new O-rings and the contact surface of the cooler refrigerant liquid pipe A with compressor oil.
ND-OIL 11 or equivalent
Install the 2 O-rings to the cooler refrigerant liquid pipe A.
Do not let foreign matter adhere to the O-rings or O-ring seals.
Engage the cooler condenser assembly and cooler refrigerant liquid pipe A.
| *a | Large Diameter Section of Piping Clamp | - | - |
Engage the parts by holding the pipe, not the piping clamp.
Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the cooler condenser assembly.
When inserting, make sure that a click sound is heard.
Check that the suction pipe sub-assembly is securely inserted by pulling it.
88703
3.CONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the discharge hose sub-assembly.
ND-OIL 11 or equivalent
Install the O-ring to the discharge hose sub-assembly.
Connect the discharge hose sub-assembly to the cooler condenser assembly with the bolt.
16593B
4.INSTALL NO. 1 RADIATOR AIR GUIDE RH
16595B
5.INSTALL NO. 1 RADIATOR AIR GUIDE LH
52131A
6.INSTALL FRONT BUMPER REINFORCEMENT
52611
7.INSTALL FRONT BUMPER ENERGY ABSORBER
16594
8.INSTALL NO. 2 RADIATOR AIR GUIDE
for M20A-FXS:
Click hereEngine / Hybrid System>M20A-FXS (COOLING)>RADIATOR>INSTALLATION
for 2ZR-FXE:
Click hereEngine / Hybrid System>2ZR-FXE (COOLING)>RADIATOR>INSTALLATION
53205
9.INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY
for M20A-FXS:
Click hereEngine / Hybrid System>M20A-FXS (COOLING)>RADIATOR>INSTALLATION
for 2ZR-FXE:
Click hereEngine / Hybrid System>2ZR-FXE (COOLING)>RADIATOR>INSTALLATION
17752
10.INSTALL NO. 2 AIR CLEANER INLET (for 2ZR-FXE)
53510
11.INSTALL HOOD LOCK ASSEMBLY
w/ Engine Hood Courtesy Switch :
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSTALLATION
w/o Engine Hood Courtesy Switch :
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY>INSTALLATION
53579
12.INSTALL HOOD LOCK NUT CAP
16561C
13.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
53117C
14.INSTALL NO. 1 RADIATOR GRILLE RETAINER
52029A
15.INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
for M20A-FXS:
Click hereEngine / Hybrid System>M20A-FXS (COOLING)>RADIATOR>INSTALLATION
for 2ZR-FXS:
Click hereEngine / Hybrid System>2ZR-FXE (COOLING)>RADIATOR>INSTALLATION
16.INSTALL HEADLIGHT ASSEMBLY LH (for Single Beam Headlight)
17.INSTALL HEADLIGHT ASSEMBLY RH (for Single Beam Headlight)
Use the same procedure as for the LH side.
18.INSTALL HEADLIGHT ASSEMBLY LH (for Triple Beam Headlight)
19.INSTALL HEADLIGHT ASSEMBLY RH (for Triple Beam Headlight)
Use the same procedure as for the LH side.
20.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
21.WARM UP COMPRESSOR
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
22.INSPECT FOR REFRIGERANT LEAK
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
53301
23.ADJUST HOOD SUB-ASSEMBLY