Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
67831C
3.INSTALL NO. 2 FRONT DOOR SERVICE HOLE COVER
68102
4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
5.INSTALL FRONT DOOR SERVICE HOLE COVER
68195
6.INSTALL FRONT DOOR BELT SEAL
68172A
7.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP
67602
8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
74231
9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
74232
10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
69284C
11.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13.INITIALIZE POWER WINDOW CONTROL SYSTEM
14.INSPECT POWER WINDOW OPERATION