Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › 2019.09–2020.08
RM32K0E _59 Vehicle Exterior _061311 WINDOW / GLASS _0302413 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.

Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.


b.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408F 4.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

Hide 68152C 5.INSTALL REAR DOOR GLASS RUN

Hide 67674A 6.INSTALL REAR DOOR FRAME GARNISH

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68199 8.INSTALL REAR DOOR BELT REAR SEAL

Hide 68197 9.INSTALL REAR DOOR BELT SEAL

Hide 67498 10.INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

Hide 67604 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67498 12.INSTALL REAR DOOR REAR FRAME BRACKET

Hide 84810D 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Hide 69284D 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16.INITIALIZE POWER WINDOW CONTROL SYSTEM