Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
53630
1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Pass the hood lock control cable assembly into the engine compartment.
Engage the grommet.
| *a | Grommet | - | - |
Connect the hood lock control cable assembly to the clamps.
53630
2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Pass the hood lock control cable assembly into the engine compartment.
Engage the grommet.
| *a | Grommet | - | - |
Connect the hood lock control cable assembly to the clamps.
53601
3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
Engage the guide.
53601
4.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53510
5.INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
Apply MP grease to the sliding areas of the hood lock assembly.
Connect the hood lock control cable assembly to the hood lock assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
53510
6.INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
53579
7.INSTALL HOOD LOCK NUT CAP
16561C
8.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
53117C
9.INSTALL NO. 1 RADIATOR GRILLE RETAINER
53876A
10.INSTALL FRONT FENDER LINER LH (for LHD)
Install the front fender liner LH with the 7 clips and 2 screws.
53875A
11.INSTALL FRONT FENDER LINER RH (for RHD)
Install the front fender liner RH with the 6 clips and 2 screws.
75860A
12.INSTALL ROCKER PANEL MOULDING LH
75602A
13.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY
14.INSTALL FRONT BUMPER ASSEMBLY
15.INSTALL FRONT WHEEL
53301
16.ADJUST HOOD SUB-ASSEMBLY