16595B
1.INSTALL NO. 1 RADIATOR AIR GUIDE LH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide LH as shown in the illustration.
16593B
2.INSTALL NO. 1 RADIATOR AIR GUIDE RH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide RH as shown in the illustration.
52134G
3.INSTALL FRONT BUMPER BRACKET LH
Install the front bumper bracket LH with the 4 bolts.
52133F
4.INSTALL FRONT BUMPER BRACKET RH
Use the same procedure as for the LH side.
52132A
5.INSTALL NO. 2 FRONT BUMPER REINFORCEMENT
Install the No. 2 front bumper reinforcement with the 2 nuts.
57014A
6.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
Engage the guides to install the front side member bracket sub-assembly LH.
Install the 4 bolts.
Engage the wire harness clamp.
57013C
7.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
Engage the guides to install the front side member bracket sub-assembly RH.
Install the 4 bolts.
52131A
8.INSTALL FRONT BUMPER REINFORCEMENT
Engage the guides to install the front bumper reinforcement.
Install the 6 bolts.
Engage the wire harness clamps.
52618
9.INSTALL LOWER FRONT BUMPER ABSORBER
|
Install in this Direction |
Engage the guides to install the lower front bumper absorber as shown in the illustration.
52611
10.INSTALL FRONT BUMPER ENERGY ABSORBER
|
Install in this Direction |
Engage the guides to install the front bumper energy absorber as shown in the illustration.
16561C
11.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
|
Install in this Direction |
Install the No. 1 radiator to support seal as shown in the illustration.
Engage the wire harness clamp and install the 2 clips.
53117C
12.INSTALL NO. 1 RADIATOR GRILLE RETAINER
|
Install in this Direction |
Engage the claws to install the No. 1 radiator grille retainer as shown in the illustration.
52536
13.INSTALL FRONT BUMPER SIDE RETAINER LH
|
Install in this Direction |
Engage the claw to install the front bumper side retainer LH as shown in the illustration.
| *a | Bolt |
| *b | Screw |
Install the screw.
Install the bolt.
52535
14.INSTALL FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52112C
15.INSTALL FRONT BUMPER EXTENSION
Engage the claws and guides to install the front bumper extension.
52129B
16.INSTALL FRONT BUMPER LOWER COVER
Install the 6 grommets.
Engage the claws and guides to install the front bumper lower cover.
Install the 2 clips and 6 outside moulding retainers.
Install the 2 screws.
52114A
17.INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET
for Extension Mounting Bracket Type A:
|
Install in this Direction |
Engage the claws to install the front bumper extension mounting bracket as shown in the illustration.
Install the 2 screws.
for Extension Mounting Bracket Type B:
|
Install in this Direction |
Engage the claws to install the front bumper extension mounting bracket as shown in the illustration.
Install the 2 screws.
52128B
18.INSTALL FRONT BUMPER HOLE COVER
Engage the hook and claws to install the front bumper hole cover.
52146B
19.INSTALL FRONT BUMPER SIDE MOUNTING BRACKET LH
Engage the claws to install the front fender liner retainer.
Engage the claws to install the front bumper side mounting bracket LH as shown in the illustration.
Install the screw and clip.
52145C
20.INSTALL FRONT BUMPER SIDE MOUNTING BRACKET RH
Use the same procedure as for the LH side.
52128B
21.INSTALL FRONT BUMPER HOLE COVER LH
Engage the claws and guide to install the front bumper hole cover LH.
52127D
22.INSTALL FRONT BUMPER HOLE COVER RH
Use the same procedure as for the LH side.
81482C
23.INSTALL FOG LIGHT COVER LH (w/ Fog Light)
Install the fog light cover LH with the 3 screws.
81481E
24.INSTALL FOG LIGHT COVER RH (w/ Fog Light)
Use the same procedure as for the LH side.
76852A
25.INSTALL FRONT SPOILER COVER LH
Install the grommet.
Engage the guides to install the front spoiler cover LH.
Install the clip.
Install the screw and 2 outside moulding retainers.
76851A
26.INSTALL FRONT SPOILER COVER RH
Use the same procedure as for the LH side.
27.INSTALL WASHER HOSE (w/ Headlight Cleaner System)
Engage the clamps to install the washer hose.
28.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
29.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
30.INSTALL HEADLIGHT WASHER COVER LH (w/ Headlight Cleaner System)
31.INSTALL HEADLIGHT WASHER COVER RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
82119C
32.INSTALL NO. 5 ENGINE ROOM WIRE (w/ Wire Harness)
Engage the clamps to install the No. 5 engine room wire.
81220
33.INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
for Bulb Type:
Click hereVehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>INSTALLATION
for LED Type:
Click hereVehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>INSTALLATION
81210A
34.INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
89347C
35.INSTALL FRONT CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89347B
36.INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89347D
37.INSTALL FRONT SIDE ULTRASONIC SENSOR RETAINER (w/ Simple Intelligent Parking Assist System)
89341L
38.INSTALL FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341K
39.INSTALL FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341M
40.INSTALL FRONT SIDE ULTRASONIC SENSOR (w/ Simple Intelligent Parking Assist System)
53111
41.INSTALL RADIATOR GRILLE
42.INSTALL FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)