Home › Engine / Hybrid System › M20A-FXS (LUBRICATION) › OIL LEVEL SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083956 M20A-FXS LUBRICATION _0404356 OIL LEVEL SENSOR A

M20A-FXS LUBRICATION  OIL LEVEL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51410 1.REMOVE NO.1 ENGINE UNDER COVER ASSEMBLY

Hide 89491 4.REMOVE ENGINE OIL LEVEL SENSOR

a.

Disconnect the engine oil level sensor connector.


b.
A434735

Remove the clip from the engine oil level sensor.


c.
A434736

Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from the engine balancer assembly.