Home › Engine / Hybrid System › M20A-FXS (LUBRICATION) › OIL LEVEL SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083956 M20A-FXS LUBRICATION _0404356 OIL LEVEL SENSOR A

M20A-FXS LUBRICATION  OIL LEVEL SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89491 1.INSTALL ENGINE OIL LEVEL SENSOR

a.

Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install a new clip to the engine oil level sensor.


c.

Connect the engine oil level sensor connector.


Hide 4.INSPECT FOR ENGINE OIL LEAK

Hide 51410 6.INSTALL NO.1 ENGINE UNDER COVER ASSEMBLY