Home › Engine / Hybrid System › 2ZR-FXE (HYBRID / BATTERY CONTROL) › WATER PUMP WITH MOTOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083958 2ZR-FXE HYBRID / BATTERY CONTROL _0404380 WATER PUMP WITH MOTOR A

2ZR-FXE HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide G9040 3.REMOVE INVERTER WATER PUMP WITH MOTOR ASSEMBLY

a.
A371729

Disconnect the inverter water pump with motor assembly connector.

NOTICE:
To prevent coolant from entering the inverter water pump with motor assembly connector, perform the following procedure.

Apply insulating tape to the connectors of the wire harness and inverter water pump with motor assembly.



b.

Remove the 2 bolts.


c.
A371730C04
0.427,0.271 0.646,0.271 0.646,0.271 0.708,0.552 true 2,0.271 2.656,0.271 true 0.292,0.177 0.469,0.385 0.177,0.208 10 true *1 2.688,0.177 2.927,0.385 0.24,0.208 10 true *2
*1 Outlet No. 1 Hybrid Water Pump Hose
*2 Inlet Hybrid Water Pump Hose


Slide the 2 clips and disconnect the outlet No. 1 hybrid water pump hose and inlet hybrid water pump hose to remove the inverter water pump with motor assembly.

NOTICE:
·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump with motor assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.