Home › Engine / Hybrid System › 2ZR-FXE (HYBRID / BATTERY CONTROL) › MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY) › from 2019.09
RM32K0E _51 Engine / Hybrid System _083958 2ZR-FXE HYBRID / BATTERY CONTROL _0404409 MOTOR GENERATOR CONTROL SYSTEM(for LITHIUM-ION BATTERY) C

2ZR-FXE HYBRID / BATTERY CONTROL  MOTOR GENERATOR CONTROL SYSTEM(for LITHIUM-ION BATTERY)  P1C2E46  Motor Generator ECU(EEPROM) Calibration / Parameter Memory Failure  


DESCRIPTION

The motor generator control ECU monitors its internal operation and will store this DTC if it detects a malfunction in its EEPROM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P1C2E46 Motor Generator ECU(EEPROM) Calibration / Parameter Memory Failure ECU internal malfunction
(EEPROM error)
(2 trip detection logic)
Inverter with converter assembly Does not come on Master Warning:
Comes on

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY)>UTILITY


1.

Connect the GTS to the DLC3.

2.

Turn the power switch on (IG) and turn the GTS on.

3.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4.

Turn the power switch off and wait for 2 minutes or more.

5.

Turn the power switch on (IG) and turn the GTS on.

6.

With power switch on (IG) and wait for 5 seconds or more.

7.

Turn the power switch off and wait for 2 minutes or more.

8.

Turn the power switch on (IG) and wait for 5 seconds or more.

9.

Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.

10.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.




PROCEDURE

1.CHECK AUXILIARY BATTERY VOLTAGE

Click herePower Source / Network>2ZR-FXE (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION

HINT:

If the auxiliary battery voltage inspection results are normal, perform the next step.


Result:
Proceed to
NEXT



NEXT

2.SIMULATION TEST
2.SIMULATION TEST
a.

Connect the GTS to the DLC3.


b.

Clear the DTCs.

Powertrain > Motor Generator > Clear DTCs
50002 395

c.

Turn the power switch on (IG) and wait for 5 seconds or more.


d.

Turn the power switch off and wait for 90 seconds or more.


e.

Turn the power switch on (IG) and wait for 5 seconds or more.


f.

Enter the following menus: Powertrain / Motor Generator / Trouble Codes.

Powertrain > Motor Generator > Trouble Codes
50001 395
Result:
Result Proceed to
P1C2E46 is output. A
P1C2E46 is not output. B



g.

Turn the power switch off.



A

B