Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › MOTOR GENERATOR CONTROL SYSTEM › from 2019.09
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404412 MOTOR GENERATOR CONTROL SYSTEM C

M20A-FXS HYBRID / BATTERY CONTROL  MOTOR GENERATOR CONTROL SYSTEM  P0E5811  DC/DC Converter Temperature Sensor 2 Circuit Short to Ground  P0E5815  DC/DC Converter Temperature Sensor 2 Circuit Short to Battery or Open  


DESCRIPTION

The motor generator control ECU (MG ECU), which is built into in the inverter with converter assembly, detects the temperature of the boost converter using the boost converter temperature sensor 2 (lower). The motor generator control ECU (MG ECU) also detects malfunctions in the boost converter temperature sensor 2 (lower) and its wiring.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0E5811 DC/DC Converter Temperature Sensor 2 Circuit Short to Ground Short to ground detected in boost converter temperature sensor 2 (lower) circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on
P0E5815 DC/DC Converter Temperature Sensor 2 Circuit Short to Battery or Open Open or short to +B detected in boost converter temperature sensor 2 (lower) circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on

Related Data List
DTC No. Data List
P0E5811
P0E5815
Boosting Converter Temperature 2 (Lower)

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>M20A-FXS (HYBRID / BATTERY CONTROL)>MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Connect the GTS to the DLC3.

2.

Turn the power switch on (IG) and turn the GTS on.

3.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4.

Turn the power switch off and wait for 2 minutes or more.

5.

Turn the power switch on (IG) and turn the GTS on.

6.

With power switch on (IG) and wait for 5 seconds or more.

7.

Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.

8.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.




PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY

NEXT

COMPLETED