Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › BATTERY BLOWER › from 2019.09
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404428 BATTERY BLOWER A

M20A-FXS HYBRID / BATTERY CONTROL  BATTERY BLOWER  INSTALLATION  


PROCEDURE

Hide G9230 1.INSTALL BATTERY COOLING BLOWER ASSEMBLY

a.

Engage the 2 claws.


b.

install the 3 bolts to install the battery cooling blower assembly.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

Be sure not to touch the fan part of the battery cooling blower assembly.

·

Do not lift the battery cooling blower assembly using the wire harness.




c.

Engage the 2 clamps.


d.

Connect the battery cooling blower assembly connector.


Hide 71033 2.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY

Hide 76974F 4.INSTALL REAR UNDER SIDE COVER LH

Hide 67918A 5.INSTALL REAR DOOR SCUFF PLATE LH

Hide 76973F 6.INSTALL REAR UNDER SIDE COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 67917A 7.INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 72693 8.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 9.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 73350C 10.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY