The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during port fuel injector assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458H
1.REMOVE NO. 2 FUEL PRESSURE SENSOR
23910A
2.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Remove the fuel pipe clamp from the fuel tube connector.
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly.
Click hereEngine / Hybrid System>M20A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION
23807
3.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Disconnect the No. 5 engine wire connector.
Remove the 2 bolts and fuel delivery pipe sub-assembly with the 4 port fuel injector assemblies from the cylinder head sub-assembly.
Be careful not to drop the port fuel injector assemblies when removing the fuel delivery pipe sub-assembly.
23891
4.REMOVE FUEL DELIVERY SPACER
Remove the 2 fuel delivery spacers from the cylinder head sub-assembly.
23291A
5.REMOVE INJECTOR VIBRATION INSULATOR
Remove the 4 injector vibration insulators from the cylinder head sub-assembly.
82125N
6.REMOVE NO. 5 ENGINE WIRE
Disconnect the 4 port fuel injector assembly connectors.
Disengage the 2 clamps to remove the No. 5 engine wire from the fuel delivery pipe sub-assembly.
23250F
7.REMOVE PORT FUEL INJECTOR ASSEMBLY
Pull the 4 port fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each port fuel injector assembly.
Attach a tag or label with the corresponding cylinder number to each port fuel injector assembly so that they can be installed to their original locations.
Cover the port fuel injector assemblies with plastic bags to prevent damage and contamination.